We make your plant dreams a reality.
New plants, reconstruction, retrofits and redesign — engineered from your production needs. As automation and equipment engineers, our experience is your advantage.
From a single retrofit to a whole new plant.
Atlanta Radar designs to the plant before the quoting process, so you can take full advantage of our engineering. We have stock designs to replace and improve most existing plants — but we are always looking for better ideas, and the best ones come from our customers' experience.
New Plants
Plant designs are based on your production needs — now and in the future. We design from your production requirements, with stock designs to replace and improve most existing plants. Our engineering uses 3D design suites to show the design against your existing equipment, before the quoting process.
- 3D design suites
- Built to production needs
- Designed before quoting
Plant Reconstruction
We rebuild and modernize existing plants in place — replacing aging equipment and controls with proven, better-performing systems while keeping you running.
- Equipment replacement
- Modern controls
- Minimal downtime
Plant Retrofits
From a single silo to whole-plant automation, we integrate cleanly with the steel and controls you already have — adding sensing, displays and auto-fill where you need them.
- Works with existing steel
- Add sensing & automation
- Phased upgrades
Plant Redesign
We often improve plant performance without a full replacement — at 1/2 to 1/3 the investment of a new plant, with no construction permits required, frequently increasing production up to two times the current output.
- 1/2–1/3 the cost
- No construction permits
- Up to 2× production
Better performance, often without a full rebuild.
The existing plant
Aging equipment, manual fills and bottlenecks that cap output and drive up maintenance.
The redesigned plant
Re-engineered flow, modern sensing and automation — frequently doubling production for a fraction of a new-build investment.
Engineered, not improvised.
Listen
We start from your production requirements and the constraints of your existing plant and site.
Design in 3D
Our engineers model the plant against your existing equipment so you see it before you commit.
Engineer & automate
Sensing, displays and custom control logic are designed in-house and tuned to your operation.
Commission
We install, wire and bring the plant up to full production, then support it for the long haul.
Improve the plant you have — for a fraction of a new build.
Replacing existing equipment usually needs no new construction permits, so reconstruction runs at 1/2 to 1/3 the investment of a new plant while lifting production.
Of a new-plant cost
Production, frequently
Construction permits
Tell us about your plant.
Share your production goals and existing equipment. Our engineers will design to your plant — in 3D — before the quote.